DATAC® V3 sound moderator + 5 barrel centerer for Bulldog.357

Big guns, big guns!

Robust, light and high-end, the DATAC® V3 sound moderator made entirely of Carbon Nylon is designed to provide you with discretion and comfort during your shooting sessions. It makes the .357 bulldog fully usable indoors and in the garden from a sound point of view.

• Makes the shot more discreet by 25 to 28 dB.

Product weight: 130g.

Length of installed product: 180 mm.

The DATAC® V3 Nylon Carbon sound suppressor will replace the factory cap of your Benjamin Bulldog and will integrate perfectly into the environment of your weapon.

Material: PA-12CF (Carbon nylon).

Composition: PA-12 CF (Carbon Nylon), high-end nylon alloy reinforced with carbon fiber. Heavyweight champion in resistance to shocks and high temperatures, used in particular in the aeronautical and automobile industries for its exceptional and unrivaled properties. The minimum recommended projectile weight is 130 grains.

Simpler installation than ever:

• Remove the factory cap using a 3/32 Allen wrench.

• Insert the V3 in place of the original cap by hand, without using tools such as a hammer or mallet.

• Fix the V3 using the carbon steel screws provided, the 12 mm one on the lower rail side, the 8 mm one on the upper side. Be careful to use the screws supplied with the V3 because the thread used is in metric units and not in inches like that present on the original part.

DATAC® your accessory professional in the field of armaments.

Metric and inch Allen key not included. An inch Allen key kit will be essential, found on Amazon for less than €10, a link will be sent to the buyer if necessary.

Installation time: approximately 1 minute.

Kit of 5 barrel centerers for BENJAMIN BULLDOG .357. Offers a gain in precision by limiting vibrations due to the floating barrel when firing.

Additive production FDM PA12-CF.

Installation of the centralizer(s):

- Approximately 15 minutes of installation.

-For safety reasons, carefully empty the entire air reserve via the bleed screw located in front of the kick connect valve. Wait 15 minutes for all the air to be evacuated.

-Disassemble the barrel protection casing by removing 2 screws at the front and one at the rear on the upper face, then push it forward to reveal the barrel.

-Remove the flexible plastic butt plate from your rifle.

-Remove the star at the end of the barrel (it is normal that it comes with difficulty).

-Insert the barrel centralizer(s) along the housing.

-Reassemble the rifle.

Benjamin Bulldog .357 and scope not included.

Please note, this product is not compatible with the use of JSB and H&N Sport pellets due to their too short profile. Leads can deviate in the moderator due to pressure variations between each cell and cause damage.